Drive Bolt replacement 14mm - 9/16

drivebolt.jpg
drivebolt.jpg

Drive Bolt replacement 14mm - 9/16

0.50

This is a replacement bolt for the gear set. If using the recommended drill set, these should last an estimated 2,000 to 3,000 cycles. Using a 1/4 or 3/8 impact will shorten your life to half that. Drive bolts are considered wear items and are not covered under warranty. Use of 1/2 impacts voids binder warranty immediately. Here is a instructional video on drive bolt replacement.

https://www.youtube.com/watch?v=nssbHlwyAA8

Quantity:
Add To Cart

Replacement drive bolt for any Torque Drive.

The 14 mm six sided socket is preferred over the 9/16. The 14 mm is a tighter fit.

My normal pricing is $7.00 per part, but because my shipping is a per part charge at $7.00 on square space, my price is 50 cents for the bolt for a total of $7.50 including shipping. Hope that makes sense.

To replace your drive bolt, simply remove your side plates, remove the retaining pin with a hole punch, pull the bolt out, replace and reassemble.

It’s literally a 5 minute job.